Repair and spare parts for Fagor boilers in Madrid
Repair and spare parts inquiry for Fagor in Madrid. Please provide the model, the symptom, and your location to confirm the scope. Independent multi-brand service from the manufacturer.
What do we need to check your Fagor boiler?
To inquire about a repair for Fagor, identify the complete model of the appliance and describe the symptom. A brand or an isolated code does not confirm a compatible spare part. Uniclima offers independent multi-brand support; this page does not certify affiliation with the manufacturer's official service.
- Identify the equipment
- Please provide an exterior photograph of the label, if accessible, along with the model of the involved units.
- Describe the problem.
- Indicate which function is failing, since when, and the exact warning that appears.
- Confirm the scope.
- Add location and access; diagnosis, spare parts, travel, and date are confirmed for each case.
Boiler services
Most common Fagor models in Madrid
- FE-24 / FE-20 N - Sealed forced draft combi boiler. The most installed model in Madrid until 2013.
- FEB-24 / FEB-20 – Forced draft twin-pipe boiler. Widely used in residential blocks.
- FEV-24 – High-power combi boiler for large homes.
- FE-24E N - version with electronic ignition. Very common in renovations 2005-2013.
- FEE (series) – heating-only boiler, for homes with independent DHW.
Most common fault codes
| Code | Meaning | Common cause |
|---|---|---|
| E1 | Ignition fault | No flame after 3 attempts: gas, electrode, or valve |
| E2 | Overtemperature | Temperature exceeded: pump or limit thermostat |
| E3 | Heating NTC sensor | Defective flow temperature sensor |
| E4 | DHW NTC sensor | Domestic hot water sensor faulty |
| E5 | Fan fault | Extractor fan motor stopped or pressure switch sensor |
| E6 | Spontaneous flame | Defective gas valve or ionisation electrode |
Fagor spare parts available
We maintain stock of the most requested spare parts and source distributor parts when possible:
- PCB control boards for FE-24 and FEB-24
- Circulator pumps (direct and equivalents)
- NTC sensors for heating and DHW
- Ignition and ionisation electrodes
- SIT gas valves and equivalents
- Extractors and fans
- Gaskets and maintenance kits
Frequently Asked Questions about Fagor Boilers
Can I repair a Fagor boiler if it is no longer manufactured?
Yes, in many cases. The FE-24 and FEB-24 models have good availability of spare parts in the distribution market, and many components are equivalent to other brands (SIT gas valves, Honeywell PCBs, Grundfos pumps). However, for very specific models or those prior to 2005, the availability of the original PCB may be limited. We assess before quoting.
Is it worth repairing an old Fagor or is it better to replace it?
Before replacing a boiler, compare the full cost of repair and new installation, equipment condition, material availability and your home's consumption. A percentage of savings or amortisation period cannot be promised without studying the case.
What does the error E1 mean on a Fagor boiler?
E1 indicates a ignition fault with safety lockout. The boiler attempted to ignite several times without detecting a flame. Check that the gas is open. The reset is done by turning the boiler off and on or pressing the reset button if it has one. If the error repeats in the first cycles, technical intervention is required.
Is there a warranty if we replace a part in a Fagor boiler?
Check applicable conditions for the equipment and contracted work: manufacturer, installation and repair do not necessarily have the same coverage. Keep the budget, invoice and documentation, without prejudice to the corresponding legal rights.
Does your Fagor boiler need servicing or repair?
Indicate the model and the fault code. We will guide you before the visit.