Saunier Duval Flow Meter Flow Detector Themafast C 28 E Ref. S5720200

Saunier Duval boilers compatible with reference S5720200

Flow meter with reference S5720200. 33 confirmed compatibilities: ThemaClassic C24E and ThemaClassic C25E.

Verified compatibility

Can't see your model or have questions? The printed reference takes precedence. How to check it · Send us a photo via WhatsApp.

How to check if ref. S5720200 is the part for your boiler

The part reference, model, and equipment revision must be verified against the manufacturer's documentation.

1. Find the reference printed on the installed part and check whether it matches the catalogue reference S5720200. If it is not visible, do not identify the part from its shape alone.
2. Check the full boiler model on its data plate and look for it in the model associations on this page.
3. Compare the connections and physical body with the original part before installation.
4. If anything is unclear, send us a photo of the marking via WhatsApp before placing your order.

Symptoms that require diagnosis in the flow meter S5720200

The flow meter detects the passage of water to activate the domestic hot water. These are the typical symptoms and what to do:

Common symptoms and faults

• 01

  No matter how much you open the tap, the hot water doesn't come and the boiler doesn't ignite the burner.

  Cause: Without the flow detector signal, the boiler does not know that there is a demand for domestic hot water and does not start.

  Measure the actual flow rate at the tap and make sure there is no clogged filter or aerator before replacing the part.

• 02

  The hot water cuts off and comes back on by itself several times while you shower or wash dishes.

  Cause: The scale or dirt in the internal mechanism of the detector causes intermittent contact losses.

  Disassemble the sensor and check if the moving part rotates freely or is stuck due to limescale.

• 03

  With low water pressure, it doesn't heat, but with the tap fully open, it does.

  Cause: The detector requires a minimum flow rate to activate the contact and request the burner ignition.

  Test with the tap fully open and check the inlet pressure and the main filter beforehand.

• 04

  There is a slight noise in the pipe when the hot water runs, which wasn't there before.

  Cause: A worn internal paddle can rub or vibrate as water passes through the sensor.

  Check if the noise changes when you open the tap more or less; if it changes with the flow rate, point to the part.

These symptoms can have more than one cause. If your boiler displays a fault code, send it to us via WhatsApp along with a photo of the labeling, and we'll tell you if this is the part.

Data sheet for the Saunier Duval S5720200 flow meter

Catalogue reference

S5720200

Uniclima internal SKU

DFTC28E

Brand

Saunier Duval

Type of part

Flow detectors

Units in stock

7 units

Status

Refurbished

Warranty

1 year

Shipping

Delivery time shown at checkout

Return

14 days

Manuals and technical documentation

Official documentation of the boiler, useful for locating the part and cross-referencing the fault codes.

• Saunier Duval Thematek S F24E Manual (PDF) Document © Saunier Duval, provided as a technical reference.