FIME GR01230 Smoke Extractor Chaffoteaux Maya 24 FF - Ref. 61304720
FIME brand flue extractor, code GR01230, for Chaffoteaux Calydra Comfort, Centora 2.24 FF, Elexia Comfort, and Maya 24 FF boilers. The manufacturer and code are listed on the part's label. It is replaced when the extractor does not start, makes excessive noise, or the boiler locks due to flue evacuation failure.
VAT included
Consult via WhatsAppChaffoteaux boilers compatible with reference 61304720
Extractor with reference 61304720. 11 verified compatibilities: Calydra Delta 24 FF and Centora 1.24 FF.
Proven compatibility
| Boiler model | Family | Verification |
|---|---|---|
| Chaffoteaux Calydra Delta 24 FF | CALYDRA | Contrasted |
| Chaffoteaux Centora 1.24 FF | CENTORA | Contrasted |
| Chaffoteaux Centora 2.24 FF | CENTORA | Contrasted |
| Chaffoteaux Centora 3.24 FF | CENTORA | Contrasted |
| Chaffoteaux Centora System 24 FF | CENTORA | Contrasted |
| Chaffoteaux Nexia 24 FF | NEXIA | Contrasted |
| Chaffoteaux Primaxia 24 FF | PRIMAXIA | Contrasted |
| Chaffoteaux Hyxia II 24 FF | HYXIA | Contrasted |
| Chaffoteaux Elexia Comfort 3.24 FF | ELEXIA | Contrasted |
| Chaffoteaux Nectra Comfort 2.24 FF | NECTRA | Contrasted |
| Chaffoteaux MC 2 24 FF | MC 2 | Contrasted |
Can't see your model or have questions? The printed reference takes precedence. How to check it · Send us a photo via WhatsApp.
How to check if ref. 61304720 is the part for your boiler
What determines it is not the boiler model, but the reference printed on the part you already have installed.
- Find the reference printed on the installed part and check whether it matches the catalogue reference 61304720. If it is not visible, do not identify the part from its shape alone.
- Check the full boiler model on its data plate and look for it in the model associations on this page.
- Compare the connections and physical body with the original part before installation.
- If anything is unclear, send us a photo of the marking via WhatsApp before placing your order.
Symptoms and faults that the extractor 61304720 resolves.
The extractor evacuates the combustion gases with forced draft. These are the typical symptoms and what to do:
Common symptoms and faults
- 01
The extractor does not start when requesting heat from the boiler, although the ignition attempt can be heard.
Cause: The FIME motor is seized or does not receive the necessary starting force to overcome the rotor's resistance.
With the boiler unplugged, try to turn the turbine by hand: if it doesn't turn freely, confirm that the motor is seized before purchasing.
- 02
Noticeable noise or vibration in the area of the fan, sometimes with the boiler shutting down by itself.
Cause: The imbalance of the turbine due to dirt or bearing wear causes vibration and, in extreme cases, overstrain of the motor.
Check if the turbine blades have dirt or grease buildup: a cleaning can eliminate the noise without replacing the part.
- 03
The boiler ignites for a moment, bleeds, and then locks out with a flue gas evacuation fault.
Cause: The extractor does not reach the revolutions that the control board needs to validate the exhaust, so it cuts off the gas for safety.
Check that the flue is not blocked and that the external terminal is not covered by ice, a nest, or dirt.
- 04
The extractor works but intermittently, it stops and starts again by itself.
Cause: It may be due to a motor that overheats and self-protects, typical of faulty bearings or damaged winding.
Note how long it takes to stop from the moment it starts: if the pattern always repeats the same, it points to a thermal problem with the motor itself.
Fault codes Chaffoteaux that this part resolves
| Code | Fault | Diagnosis and solution |
|---|---|---|
| E 23 | Low fan speed. | The extractor fan (Fime MC 2 24 FF) is running below the setpoint or not delivering the expected tachometer frequency/voltage; check 230 V to the motor and the tacho signal from the 3rd wire to the PCB, as well as impellers/bearings and obstructions in the duct. |
| E 24 | Extractor operation control fault. | The PCB commands extraction but does not receive feedback from the fan speed sensor (integrated tachometer/3 wires); check power supply to the fan and continuity/tacho signal. If there is voltage and no feedback, the extractor is faulty. |
These symptoms can have more than one cause. If your boiler displays a fault code, send it to us via WhatsApp along with a photo of the labeling, and we'll tell you if this is the part.
Chaffoteaux 61304720 fan datasheet
- Catalogue reference
- 61304720
- Brand
- Chaffoteaux
- Type of part
- Extractors
- Units in stock
- 5 units
- Status
- Refurbished
- Warranty
- 1 year
- Shipping
- 1-2 business days
- Return
- 14 days
Data read on the part and in the manufacturer's documentation
What we have not been able to verify does not appear here.
- Manufacturer
- FIME
- Component code
- GR01230
Frequently asked questions about the extractor 61304720
Which brand manufactures the extractor for the Chaffoteaux Maya 24 FF?
What FIME code is marked on the extractor of the Elexia Comfort 24 FF?
Is this extractor FIME GR01230 suitable for my Chaffoteaux Calydra Comfort 24 FF?
Is the reference 61304720 the code that appears on the label of the extractor of the Centora 2.24 FF?
When should the extractor of the Chaffoteaux Maya 24 FF be replaced?
Spare parts related to Chaffoteaux CENTORA
