Ferroli Domiproject F24 Flow Switch Ref. 39818552

Ferroli boilers compatible with reference 39818552

Flow meter with reference 39818552. 11 verified compatibilities: Domiproject F24 and Domiproject F24 D.

Proven compatibility

Can't see your model or have questions? The printed reference takes precedence. How to check it · Send us a photo via WhatsApp.

How to check if the ref. 39818552 is the part for your boiler

The part reference, model, and equipment revision must be verified against the manufacturer's documentation.

1. Find the reference printed on the installed part and check whether it matches the catalogue reference 39818552. If it is not visible, do not identify the part from its shape alone.
2. Check the full boiler model on its data plate and look for it in the model associations on this page.
3. Compare the connections and physical body with the original part before installation.
4. If anything is unclear, send us a photo of the marking via WhatsApp before placing your order.

Symptoms that require diagnosis in the flow meter 39818552

The flow meter detects the passage of water to activate the domestic hot water. These are the typical symptoms and what to do:

Common symptoms and faults

• 01

  The boiler does not ignite to provide hot water or heating, even though the tap is fully open and there is pressure.

  Cause: The flow detector does not close the contact, and the boiler understands that there is no water circulation, so it does not allow the burner to ignite.

  Check that there is no blocked inlet filter and that the installation pressure is within its range before declaring the part defective.

• 02

  The burner starts for a moment and then cuts off immediately, delivering water in bursts.

  Cause: The contact of the detector makes intermittent contact due to wear or internal dirt and sends intermittent flow signals to the boiler.

  Bleed the circuit to eliminate air and check if the cut coincides with pressure variations before replacing the part.

• 03

  The boiler shows a warning of lack of circulation even though the system is full and bled.

  Cause: The detector may get stuck in the open position and continue reporting a lack of flow even though water is circulating.

  Check that the pump is circulating normally and that no shut-off valves are partially closed before replacing the sensor.

• 04

  There is a small ring of moisture or dripping near the part, close to the connector.

  Cause: The plastic body of the detector ages with heat cycles and may lose tightness due to the gasket.

  Dry the area, turn on the boiler, and locate whether the water is coming from the detector itself or from a nearby fitting before purchasing the spare part.

These symptoms can have more than one cause. If your boiler displays a fault code, send it to us via WhatsApp along with a photo of the labeling, and we'll tell you if this is the part.

Flow meter data sheet Ferroli 39818552

Catalogue reference

39818552

Uniclima internal SKU

DCCDPF24D

Brand

Ferroli

Type of part

Flow detectors

Units in stock

4 units

Status

Refurbished

Warranty

1 year

Shipping

Delivery time shown at checkout

Return

14 days

Part data and available documentation

Contrast the label codes, PCB, and revision with the installed part; they are not necessarily equivalent references.

Mold marking

10022346

Manuals and technical documentation

Official documentation of the boiler, useful for locating the part and cross-referencing the fault codes.

• Ferroli Domiproject F24 D Manual (PDF) Document © Ferroli, provided as a technical reference.