Zilmet Plate Heat Exchanger for Fagor Boiler CE-30E - Ref. MU0886000

Fagor boilers compatible with reference MU0886000

Plate heat exchanger with reference MU0886000. 11 verified compatibilities: CE 24 E and CE 30 E.

Proven compatibility

Can't see your model or have questions? The printed reference takes precedence. How to check it · Send us a photo via WhatsApp.

How to check if the part number MU0886000 is the one for your boiler

The part reference, model, and equipment revision must be verified against the manufacturer's documentation.

1. Find the reference printed on the installed part and check whether it matches the catalogue reference MU0886000. If it is not visible, do not identify the part from its shape alone.
2. Check the full boiler model on its data plate and look for it in the model associations on this page.
3. Compare the connections and physical body with the original part before installation.
4. If anything is unclear, send us a photo of the marking via WhatsApp before placing your order.

Symptoms that require diagnosis in the plate heat exchanger MU0886000

The plate heat exchanger transfers heat to the domestic hot water. These are the typical symptoms and what to do:

Common symptoms and faults

• 01

  There is no domestic hot water, or it comes out with very low pressure.

  Cause: The domestic hot water heat exchanger does not allow water to pass due to blockages in the plates.

  Open the domestic hot water tap fully and compare the flow rate with that of the cold water from the same outlet.

• 02

  The hot water comes out lukewarm, neither cold nor really hot.

  Cause: The plates of the heat exchanger have deposits that prevent complete heat transfer.

  Increase the domestic hot water setting and test with the tap slightly open: if it improves by reducing the flow rate, it is likely that the heat exchanger is scaled.

• 03

  Water is appearing in the area where the heat exchanger is located.

  Cause: The plates or gaskets of the heat exchanger may be leaking due to wear.

  Dry the area, turn on the boiler, and check if the dripping comes from the heat exchanger.

• 04

  The heating pressure is low without any visible leaks outside the boiler.

  Cause: An internal perforation in the heat exchanger can allow water to mix between the heating and domestic hot water circuits.

  Fill it up to the correct pressure and check if it drops again in a few hours without any visible water on the floor.

These symptoms can have more than one cause. If your boiler displays a fault code, send it to us via WhatsApp along with a photo of the labeling, and we'll tell you if this is the part.

Plate heat exchanger data sheet Fagor MU0886000

Catalogue reference

MU0886000

Uniclima internal SKU

IPCMCE30E

Brand

Fagor

Type of part

Plate heat exchanger

Units in stock

7 units

Status

Refurbished

Warranty

1 year

Shipping

Delivery time shown at checkout

Return

14 days

Part data and available documentation

Contrast the label codes, PCB, and revision with the installed part; they are not necessarily equivalent references.

Manufacturer

Zilmet

Code

MU0886000

Manuals and technical documentation

Official documentation of the boiler, useful for locating the part and cross-referencing the fault codes.

• Fagor CE 30 E Manual (PDF) Document © Fagor, provided as a technical reference.